This is an old revision of the document!

Front Panel Description

2 Dual VHDCI Connectors (LVDS,LVCMOS3.3V) (Mates with Amphenol CS-VHDCIMX200-003)
2 Dual LEMO Connectors (LVCMOS 3.3V/TTL 5V)
1 Micro-USB (USB UART) (Mates with Molex 0687840001)
4×4 LEDS (X0 LEDs are for Asad0, X1 LEDs are for Asad1, etc)
- P = Asad Plugged
  - ON: Asad plugged in
  - OFF: No Asad plugged
  - Slow Blink: (configuration dependent?)
  - Fast Blink: ?
- B = Bad
  - ON: Major error. Typically needs user intervention. Power supply error? unresponsive to slow control or reset.
  - OFF: no errors
  - Slow Blink: Slow control errors e.g. AGET controller busy, etc.
  - Fast Blink: bad data frames.
- U = CoBo-Asad Uplink activity i.e. from CoBo to Asad
  - ON: ?
  - OFF: no activity
  - Slow Blink: minor traffic
  - Fast Blink: major traffic
- D = CoBo-Asad Downlink activity i.e. from Asad to CoBo
  - ON: All or 3 Asads sending data
  - OFF: no data from asad
  - Slow Blink: slow control replies
  - Fast Blink: 2 or less Asads sending data
3 MicroTCA LEDS
- Blue = Hot swap
- Green = OK
- Red = Bad

CoBo 0.2v

The difference between the two front panels is the arragement of LEMO connectors