This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
test [2024/11/04 11:54] sunli |
test [2025/02/22 19:48] (current) sunli |
||
---|---|---|---|
Line 15: | Line 15: | ||
2) In lab 1035, the highest vacuum I've achieved is 1.47E-7 torr. The copper gaskets on the top flange and two side flanges have been reused numerous times. To achieve the high vacuum required by the beamline, it is recommended that new gaskets be purchased.\\ | 2) In lab 1035, the highest vacuum I've achieved is 1.47E-7 torr. The copper gaskets on the top flange and two side flanges have been reused numerous times. To achieve the high vacuum required by the beamline, it is recommended that new gaskets be purchased.\\ | ||
- | 3) There was a twin of MSD12 manufactured by Micron in the same batch. If we get rich, purchase it as a backup.\\ Also, consider upgrading to larger area MSD detectors, such as MSD85.\\ | + | 3) There was a twin of MSD12 manufactured by Micron in the same batch. If we get rich, purchase it as a backup. |
4) The CP5 plus coldhead can be equipped with water-cooled heat sinks | 4) The CP5 plus coldhead can be equipped with water-cooled heat sinks | ||
Line 34: | Line 34: | ||
===== XtRa Status Monitor ===== | ===== XtRa Status Monitor ===== | ||
{{ :: | {{ :: | ||
+ | {{ ::south.zip |}}\\ | ||
{{ :: | {{ :: | ||
{{ :: | {{ :: | ||
Line 118: | Line 118: | ||
{{ :: | {{ :: | ||
{{ : | {{ : | ||
+ | {{ :: | ||
+ | {{ :: | ||
{{ :: | {{ :: | ||
Line 132: | Line 133: | ||
{{ : | {{ : | ||
{{ :: | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ :: | ||
+ | {{ : | ||
+ | |||
===== Data Acquisition System ===== | ===== Data Acquisition System ===== | ||
Line 156: | Line 170: | ||
{{:: | {{:: | ||
{{: | {{: | ||
+ | |||
+ | source logs backup:\\ | ||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : |