Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
daq:fastscint_daq [2017/04/07 08:42] peter_bender [FastScint DAQ] |
daq:fastscint_daq [2017/04/07 11:26] (current) peter_bender [FastScint DAQ] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| == Starting the DAQ == | == Starting the DAQ == | ||
| - | The LaBr array is currently run from the **fastscint** account on **spdaq45**, for long in help, think of Cs. | + | * Currently, the fastscint DAQ is run from a shell on **u6pc5** (the s800 machine) to **spdaq45**. **spdaq45** is physically located in the rack on the ground floor of S3 on the north side of the s800. |
| + | |||
| + | * The LaBr array is currently run from the **fastscint** account on **spdaq45**. For log-in help, think of Cs. | ||
| + | * to start the GUI control, run: | ||
| + | |||
| + | <code> | ||
| + | ~/DAQ/readout_vme/guireadout | ||
| + | </code> | ||
| + | |||
| + | {{ :daq:guireadout.png?400 |}} | ||
| + | |||
| + | * Note the record check-box located just below the button grouping on the readout GUI (pictured above). It is important that this box is **NOT** checked. Data will always be recorded by the GEB in the Global.dat file. | ||
| + | |||
| + | * Similar to the s800 DAQ, the labr daq is meant to be enslaved by the master control currently run on **u6pc2** | ||
