This is an old revision of the document!
When changing flux for FSEE, you'll want to first use the MHB and attenuators to make adjustments.
If you are going to change to a low flux around 1E3 pps/cm2, then you'll want to follow the steps below:
1. Switch FC_1102 cup to tetram reading on the FC Overview page. 2. Calculate the amount of flux needed on FC_2596 by using the calculator on the FSEE GUI. 3. Measure current on FC_2596 and record the current reading. Do the same on FC_1102. 4. Calculate the ratio between the FC_1102/FC_2596. Multiply this ratio and the desired up reading on FC_2596. This will be the reading you'll want to attain on FC_1102. 5. Put the beam back onto FC_1102 and adjust attenuators/the MHB to achieve the calculated value from the step before. 6. Insert the viewer to perform another uniformity measurement. 7. Send flux to the users /calibrate the jaws. 8. Beam is ready.