task:frib_beam_destination

This is an old revision of the document!

Sending beam to a new destination

Steps

Check the MPS Device Configuration Guideline for power limits and special notes
Calculate beam power
Configure chopper
Configure MPS
- Coordinate with AP for whether cavities need monitoring
- Calculate thresholds in Diag MPS page
  - Using the new beamloss threshold configuration tool
Configure DCCTs if needed
- Setting DCCTs
Set beam inhibit mode
Send beam

Links

Limiting Primary Beam Power → This operator page has a lot of important information about the devices involved and how they work
FRIB MPS Device Configuration Guideline

task/frib_beam_destination.1727896167.txt.gz · Last modified: 2024/10/02 15:09 by pirkola