task:frib_beam_destination
This is an old revision of the document!
Sending beam to a new destination
Steps
- Check the MPS Device Configuration Guideline for power limits and special notes
- Calculate beam power
- Configure chopper
- Configure MPS
- Coordinate with AP for whether cavities need monitoring
- Calculate thresholds in Diag MPS page
- Configure DCCTs if needed
- Set beam inhibit mode
- Send beam
Links
- Limiting Primary Beam Power → This operator page has a lot of important information about the devices involved and how they work
task/frib_beam_destination.1727857694.txt.gz · Last modified: 2024/10/02 04:28 by powersa