task:exp_open_close
This is an old revision of the document!
Open/Close EXP area
Open
- Stop Beam from running.
- Insert FC D1102.
- In the EXP Launch page, under status tab, open the T-Hall/EXP Operator page. Then insert beam stop for required area.
- On the MPS Operator page, turn the E-Bends off.
- On the PPS rack, turn the key for Linac ACS to power permit.
- On the PPS rack, turn the EXP Vault Ready for Beam key to off.
Close
- Turn EXP Vault Ready for Beam key to On.
- Turn Linac ACS to beam permit.
- On EXP page, remove beam stop that was inserted.
- Remove FC D1102 from beam line.
- Turn E-Bends On.
- Start Chopper.
task/exp_open_close.1729629815.txt.gz · Last modified: 2024/10/22 16:43 by painter