task:atten_threshold
This is an old revision of the document!
Setting the attenuator threshold interlock
As of OSE Revision 11 it is no longer necessary to set an attenuator threshold interlock any time primary beam is being sent past the target dump. The feature of locking attenuators in place still exists within the PPS rack.
The form below goes through the steps to calculate the threshold. Once calculated, the threshold is set in the PPS rack.
It is important to note that while the threshold is in place, the attenuators may not be changed without moving out of beam permit.
Links
task/atten_threshold.1756966746.txt.gz · Last modified: 2025/09/04 02:19 by harvey