FRIB Operators

Similar to the dipoles in FS1, the super conducting magnets are also used to alter the beams path, however these magnets are stronger than the dipoles. To achieve their stronger magnetic fields, these magnets have coiled wires made of special material. Due to the material, when their temperature is dropped incredibly low, below ~10 K, the wires can then conduct without any resistance. This then allows for larger magnetic fields to be generated. With the increased strength, they are used to bend the beam after it leaves LS2 and moves through FS2 since the by the time beam leaves LS2 it has done most of its acceleration.

FS2

• Yoonhyuck Choi
• Xiaoji Du
• Danlu Zhang
• Hai nguren
• Junseong Kim
• Hengkang Zheng

SCM Shift Schedule

• Shane:SCM does not only have dipoles, they also own the solenoids and the CIQT's in ARIS, (Cold-Iron Quadrupole Triplets), which are both focusing devices primarily
• Shane: the coiled wires ARE the electromagnets, also could be clearer that the lower resistance allows for greater currents to pass through with lower voltages and less losses, current language is unclear
• Shane: we have to start being careful here, I don't know where you sourced 10K, but it depends on the material. I don't know what they use, but the only figure I would be comfortable giving is <30K, as anything above that would be classified high temp and probably use nitrogen. We can't start putting unflagged speculation in here and might be good to site sources with these more technical pages
• Shane: LS1 has SCM via solenoids, I think you're right that the FS2 Dipoles are the first SC Dipoles though
• Shane: Phrasing of “With the increased strength, they are used to bend the beam after it leaves LS2 and moves through FS2 since the by the time beam leaves LS2 it has done most of its acceleration.” sounds awkward
• Shane: Wish we had some numbers or theory here, that'd be a bigger change wiki-wide though
• Shane: Not just found in LS2
• Shane: still don't like the personnel category, Hai Nguyen.