FRIB Operators

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Sending beam to a new destination ======


==== Steps ====

  * Check the MPS Device Configuration Guideline for power limits and special notes
  * Calculate beam power with the [[phys_calc|physics calculator]]
  * Configure chopper
  * [[mps_config|Configure MPS]]
    * Coordinate with AP for whether cavities need monitoring
    * Calculate thresholds in Diag MPS page 
      * [[task:beamloss_tool|]]
  * Configure DCCTs if needed
    * [[task:dcct_config|]]
  * Set beam inhibit mode
  * Send beam

==== Notes From Shane :)====
  * phys calc isn't really necessary with the beam power calc on MPS operator, worth a mention and probably easier to use for newer operator
  * Also the importance of double checking Energy and Stripping eff especially would be a good tip
  * note that cw  is 100hz, 9950us
  * wouldn't include cavitiy monitoring, AP normally asks for this and immediately wants it done so it can be done in the moment without any surprise, also this opens the can of worms on how to accomplish this without explaining it
  * You don't calculate anything in the Diag page, do you mean 5521 and Scott's tool?
  * DCCTs are only for going past the target, generally I'd leave that as a separate section as you otherwise need to get into the weeds with checking the ARIS post etc.
  * I'd probably do inhibit modes earlier, not a huge issue but similar to prev notes it's a bigger issue that I think could use more detail


===== Links =====

  * [[limiting_beam]] -> This operator page has a lot of important information about the devices involved and how they work
  * [[phys_calc]]
  * [[dcc>WBS=S30103&Sub=RC&SN=008105|FRIB MPS Device Configuration Guideline]]