Differences

This shows you the differences between two versions of the page.

--- task:phys_calc [2024/11/12 07:49] – adjusted titles pirkola
+++ task:phys_calc [2025/08/21 12:26] (current) – ryans
@@ Line 3: / Line 3: @@
 ==== Calculating Power ====
-  - Direct yourself to either the **Physics Calc** or **MPS Operator** page, located on the FRIB Launch Page.
+  - Direct yourself to either the [[pages:phy_calc|Physics Calculator]] or [[pages:mps_op|MPS Operator]] page, located on the FRIB Launch Page.
   - If on the **Physics Calc** page, look at the bottom left of the page for //Atten. Power Calc//. On **MPS Operator** you will find this in the upper right, under the //Beam Power// and //Super Convenient Controls// panels.
   - If you want to predict __Power__ using __Current__, use //Attenuation Power Calc//. If you want to predict __Current__ using your desired __Power__, click //Atten. Current Calc// directly to the right of //Atten. Power Calc//.
@@ Line 12: / Line 12: @@
       - __Stripping Efficiency (%)__ - Display 1 if available, but Diag and AP have different methods
   - Depending on your menu selection for Step 3, you'll have to find one of the following, which can be found in the following location:
-      - __1102 Current uA__ - FRIB Launcher -> Diag Operator. Look down into //Faraday Cups// and find //1102//.
+      - __1102 Current uA__ - FRIB Launcher -> Diag Operator. Look down into //Faraday Cups// and find //1102//. **Note:** If you're on __MPS Operator__ there will be an automatic readback that gets the value from //1102// and displays a constantly updating power estimation.
       - __Power__ - Consult limits or desired power from other sources
   - From there, ensure all values are properly entered, then consult the calculated bottom value,