task:pdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| task:pdt [2025/06/12 18:15] – painter | task:pdt [2025/06/12 18:31] (current) – painter | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| During PDT, AP will take the beam to develop it. A variety of tasks will be required to support AP during this time and are listed below. | During PDT, AP will take the beam to develop it. A variety of tasks will be required to support AP during this time and are listed below. | ||
| - | * AP will be changing destinations and beam power as development goes on. When doing so they will communicate to operators where beam will be going and what power it will be at. During this, operators will need ensure that we are in the correct machine mode in the PPS rack, corrects MPS configuration, | + | * AP will be changing destinations and beam power as development goes on. When doing so they will communicate to operators where beam will be going and what power it will be at. During this, operators will need ensure that we are in the correct machine mode in the PPS rack, corrects MPS configuration[[https:// |
| * Operators will need to select the correct destination and beam power while AP tunes. To do so, navigate to the DIAG MPS Devices on Phoebus: MPS Operator → DIAG MPS Devices(tab up top of MPS Operator page). This will bring you to the Diag TCT Overview page where you can change the phase of beam tuning that AP is in. In the tabs for PDT Phase 1 & 2, you can change the beam destination and beam power; in the Production tab and phase you will update the destination power. | * Operators will need to select the correct destination and beam power while AP tunes. To do so, navigate to the DIAG MPS Devices on Phoebus: MPS Operator → DIAG MPS Devices(tab up top of MPS Operator page). This will bring you to the Diag TCT Overview page where you can change the phase of beam tuning that AP is in. In the tabs for PDT Phase 1 & 2, you can change the beam destination and beam power; in the Production tab and phase you will update the destination power. | ||
| * AP will change beam power while they tune. To change the power with the Chopper, follow the instructions here: [[https:// | * AP will change beam power while they tune. To change the power with the Chopper, follow the instructions here: [[https:// | ||
task/pdt.txt · Last modified: 2025/06/12 18:31 by painter