task:open_close_target_area
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| task:open_close_target_area [2025/08/21 12:31] – ryans | task:open_close_target_area [2025/08/21 12:32] (current) – ryans | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| - Ensure you are in required machine mode for beam. | - Ensure you are in required machine mode for beam. | ||
| - Turn the Linac ACS key back to Beam Permit. | - Turn the Linac ACS key back to Beam Permit. | ||
| - | - On the Main Magnets page, cycle the D5578 dipole to 90 A on the BBS/FFS tab: | + | - On the [[pages: |
| - Copy the current setpoint value. | - Copy the current setpoint value. | ||
| - Turn on D5578 dipole (this will take a few seconds to go green). | - Turn on D5578 dipole (this will take a few seconds to go green). | ||
| Line 24: | Line 24: | ||
| - When done ramping to 90 A, paste the original setpoint value. | - When done ramping to 90 A, paste the original setpoint value. | ||
| - Wait for dipole to ramp to original value. | - Wait for dipole to ramp to original value. | ||
| - | - On the MPS Operator page, turn the E-Bends on. | + | - On the [[pages: |
| - | - On the Main Magnets page check that the E-Bends setpoint and readback values match on the V-LEBT tab. | + | - On the [[pages: |
| - | - On the MPS Operator page, set configuration according to MPS Device Configuration Guideline. | + | - On the [[pages: |
| - Check and clear all set MPS devices. | - Check and clear all set MPS devices. | ||
| - Start the Chopper. | - Start the Chopper. | ||
task/open_close_target_area.1755793867.txt.gz · Last modified: 2025/08/21 12:31 by ryans