Differences

This shows you the differences between two versions of the page.

--- task:open_close_target_area [2025/08/21 12:30] – ryans
+++ task:open_close_target_area [2025/08/21 12:32] (current) – ryans
@@ Line 4: / Line 4: @@
   - Turn the Beam/Chopper off
   - On the [[pages:mag_main|Main Magnets]] page, turn Dipole D5578 off on BBS/FFS tab; this will take a moment to ramp down to 0 A.
-  - On the MPS Operator page, turn E-Bends off.
+  - On the [[pages:mps_op|MPS Operator]] page, turn E-Bends off.
   - On the PPS rack, turn the Linac ACS key to Power Permit.
   - On the PPS rack, turn the key for Target RSS Ready For Beam to Off.
@@ Line 18: / Line 18: @@
   - Ensure you are in required machine mode for beam.
   - Turn the Linac ACS key back to Beam Permit.
-  - On the Main Magnets page, cycle the D5578 dipole to 90 A on the BBS/FFS tab:
+  - On the [[pages:mag_main|Main Magnets]] page, cycle the D5578 dipole to 90 A on the BBS/FFS tab:
       - Copy the current setpoint value.
       - Turn on D5578 dipole (this will take a few seconds to go green).
@@ Line 24: / Line 24: @@
       - When done ramping to 90 A, paste the original setpoint value.
       - Wait for dipole to ramp to original value.
-  - On the MPS Operator page, turn the E-Bends on.
+  - On the [[pages:mps_op|MPS Operator]] page, turn the E-Bends on.
-  - On the Main Magnets page check that the E-Bends setpoint and readback values match on the V-LEBT tab.
+  - On the [[pages:mag_main|Main Magnets]] page check that the E-Bends setpoint and readback values match on the V-LEBT tab.
-  - On the MPS Operator page, set configuration according to MPS Device Configuration Guideline.
+  - On the [[pages:mps_op|MPS Operator]] page, set configuration according to MPS Device Configuration Guideline.
   - Check and clear all set MPS devices.
   - Start the Chopper.