Differences

This shows you the differences between two versions of the page.

--- task:mps_config [2025/09/04 02:31] – harvey
+++ task:mps_config [2025/09/04 02:37] (current) – harvey
@@ Line 19: / Line 19: @@
 ==== Cavity Config ====
 When a mode requires watching cavities, the tool will normally enable watching all cavities in the relevant sections.  In some cases not all cavities are being used, so to aid in only watching the needed cavities you can use the Cavity Config options.
+To use Cavity Config tool on MPS Configuration tool with new cavity configuration, do the following:
+  -Click "Save Cavity Config" button.
+  -Check time stamp display
+  -Check "Use Cavity Config" checkbox.
 To toggle whether MPS is watching any specific cavity, do the following:
@@ Line 24: / Line 29: @@
   -Scroll down until you see the following:
   -{{:task:mps_cav_config.png?400|}}
-  -Click ''OFF'' or ''ON'' to either start or stop watching cavities in the corresponding section
+  -Click ''OFF'' or ''ON'' to either start or stop watching ALL cavities in the corresponding section
   OR
   -Scroll to find any specific cavities
@@ Line 30: / Line 35: @@
   -{{:task:mps_toggles.png?400|}}
   -Don't forget to cycle MPS to update!
+  NOTE: These buttons may need a few moments to apply relevant settings, or they may not work at all. This problem needs to be investigated further. DO NOT use this tool unless you double check its work.
 ===== Links =====
 [[dcc>WBS=S30103&Sub=RC&SN=008105|MPS Device Configuration Guideline]]