Differences

This shows you the differences between two versions of the page.

--- task:mps_config [2025/09/04 02:21] – harvey
+++ task:mps_config [2025/09/04 02:37] (current) – harvey
@@ Line 15: / Line 15: @@
   - Make sure the correct stripper is selected.
   - If everything looks correct click the Set MPS Configuration button to apply it.
+  - Double check settings on MPS Operator page.
 ==== Cavity Config ====
 When a mode requires watching cavities, the tool will normally enable watching all cavities in the relevant sections.  In some cases not all cavities are being used, so to aid in only watching the needed cavities you can use the Cavity Config options.
+To use Cavity Config tool on MPS Configuration tool with new cavity configuration, do the following:
+  -Click "Save Cavity Config" button.
+  -Check time stamp display
+  -Check "Use Cavity Config" checkbox.
 To toggle whether MPS is watching any specific cavity, do the following:
-  *Open the [[pages:mps_op|MPS Operator page]]
+  -Open the [[pages:mps_op|MPS Operator page]]
-  *Scroll down until you see the following:
+  -Scroll down until you see the following:
-  *{{:task:mps_cav_config.png?400|}}
+  -{{:task:mps_cav_config.png?400|}}
-  *Click ''OFF'' or ''ON'' to either start or stop watching cavities in the corresponding section
+  -Click ''OFF'' or ''ON'' to either start or stop watching ALL cavities in the corresponding section
   OR
-  *Scroll to find any specific cavities
+  -Scroll to find any specific cavities
-  *Click both buttons corresponding to any cavities you'd like to toggle until they're either on or off, as shown:
+  -Click both buttons corresponding to any cavities you'd like to toggle until they're either on or off, as shown:
-  *{{:task:mps_toggles.png?400|}}
+  -{{:task:mps_toggles.png?400|}}
-  *Don't forget to cycle MPS to update!
+  -Don't forget to cycle MPS to update!
+  NOTE: These buttons may need a few moments to apply relevant settings, or they may not work at all. This problem needs to be investigated further. DO NOT use this tool unless you double check its work.
 ===== Links =====
 [[dcc>WBS=S30103&Sub=RC&SN=008105|MPS Device Configuration Guideline]]