Differences

This shows you the differences between two versions of the page.

--- task:limiting_beam [2024/09/30 09:43] – ↷ Page moved from limiting_beam to task:limiting_beam pirkola
+++ task:limiting_beam [2025/07/08 05:35] (current) – harvey
@@ Line 1: / Line 1: @@
 ====== Limiting Primary Beam Power ======
-Please see the [[limiting_beam_background|background]] page for more information about these specific devices. This page will lead you through how to limit primary beam power using the following devices.
+Please see the [[info:limiting_beam_background|background]] page for more information about these specific devices. This page will lead you through how to limit primary beam power using the following devices.
 ==== Chopper ====
   - Determine needed beam power by consulting AP and/or relevant destination power limits
@@ Line 31: / Line 31: @@
     * HPECR source has slit gap control, use this tool unless instructed otherwise
+====Shane Notes====
+  * Primer on CW Beam might be good to start off the chopper section
+  * It'd be neat to include the "why" of peak power not being affected by the chopper, but probably not necessary here. This should be put in the info page for the Chopper as a device.
+  * We can change attenuators with beam on D1102, due to how unreliable attenuators are I would prefer a new operator to keep beam on the cup and see the changes more or less in real time, helps build intuition
+  * All of these should reference the location of the pages, even if it changes in the future attenuators and slits can be hard to find for new guys
+  * Slits should keep the same center, this isn't clearly relayed for ARTEMIS slits
+  * Slits are used for smaller adjustments, this should be laid out more clearly