Differences

This shows you the differences between two versions of the page.

--- task:k500_qtkm [2025/07/08 10:05] – lange
+++ task:k500_qtkm [2025/07/08 10:07] (current) – lange
@@ Line 19: / Line 19: @@
 === Knob Rate ===
-The rate that the knobs adjust devices settings may be controlled by right clicking on the "S" field. This brings up a dialog box where the rate can be modified. Electrostats whose settings are ~10000 V will need a higher knob rate (100), and devices with low settings like corrector magnets at 0.5 amps will need a lower rate (0.1)
+The rate that the knobs adjust devices settings may be controlled by right clicking on the "S" field. This brings up a dialog box where the rate can be modified. Electrostats whose settings are ~10000 V will need a higher knob rate (100), and devices with low settings like corrector magnets at 0.5 amps will need a lower rate (0.1). If you are tuning a device and it requires numerous turns of the knob to see a change in beam, you may need to increase the knob rate. If the knob is too sensitive, lower the rate.