task:hpecr_recovery
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| task:hpecr_recovery [2025/03/18 17:01] – painter | task:hpecr_recovery [2025/03/18 17:03] (current) – painter | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| - Turn on PLC commands | - Turn on PLC commands | ||
| - Reset all interlocks / safety interlocks again | - Reset all interlocks / safety interlocks again | ||
| - | - Turn on BEAM power supply ISC2_HVP_D0652 | + | - Turn on BEAM power supply ISC2_HVP_D0652 |
| + | - Turn back on the acceleration column puller PSEL D0678. | ||
| - Reset "RF OUTPUT Set point" to ZERO | - Reset "RF OUTPUT Set point" to ZERO | ||
| - Turn ON RF output | - Turn ON RF output | ||
| - Recover the RF output power to where it was by 100V/ | - Recover the RF output power to where it was by 100V/ | ||
| - | + | ||
| - | *Go back to the HPECR operator page, turn on both source high voltage and platform high voltage HVP D0652 and HVP D0677. | + | |
| - | *Turn back on the acceleration column puller PSEL D0678. | + | |
task/hpecr_recovery.1742331700.txt.gz · Last modified: 2025/03/18 17:01 by painter