task:closing_area
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| task:closing_area [2024/10/08 23:41] – added document links pirkola | task:closing_area [2024/11/12 07:45] (current) – let dipole sit at max for a while pirkola | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| - Turn on D5578 dipole (this will take a few seconds to go green). | - Turn on D5578 dipole (this will take a few seconds to go green). | ||
| - When the dipole is on, input 90 A into the setpoint value. | - When the dipole is on, input 90 A into the setpoint value. | ||
| - | - When done ramping to 90 A, paste the original setpoint value. | + | - When done ramping to 90 A, let it sit for about a minute. |
| + | - Paste the original setpoint value and set the magnet to it. | ||
| - Wait for dipole to ramp to original value. | - Wait for dipole to ramp to original value. | ||
| - On the MPS Operator page, turn the E-Bends on. | - On the MPS Operator page, turn the E-Bends on. | ||
task/closing_area.1728445292.txt.gz · Last modified: 2024/10/08 23:41 by pirkola