task:closing_area
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| task:closing_area [2024/10/08 10:52] – painter | task:closing_area [2024/11/12 07:45] (current) – let dipole sit at max for a while pirkola | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| - Turn on D5578 dipole (this will take a few seconds to go green). | - Turn on D5578 dipole (this will take a few seconds to go green). | ||
| - When the dipole is on, input 90 A into the setpoint value. | - When the dipole is on, input 90 A into the setpoint value. | ||
| - | - When done ramping to 90 A, paste the original setpoint value. | + | - When done ramping to 90 A, let it sit for about a minute. |
| + | - Paste the original setpoint value and set the magnet to it. | ||
| - Wait for dipole to ramp to original value. | - Wait for dipole to ramp to original value. | ||
| - On the MPS Operator page, turn the E-Bends on. | - On the MPS Operator page, turn the E-Bends on. | ||
| Line 20: | Line 21: | ||
| - Check and clear all set MPS devices. | - Check and clear all set MPS devices. | ||
| - Start the Chopper. | - Start the Chopper. | ||
| + | |||
| + | |||
| + | |||
| + | ===== Links ===== | ||
| + | * [[clist> | ||
| + | * [[dcc> | ||
| + | |||
task/closing_area.1728399168.txt.gz · Last modified: 2024/10/08 10:52 by painter