Differences

This shows you the differences between two versions of the page.

--- dev:slits [2025/08/20 13:08] – created ryans
+++ dev:slits [2025/08/21 12:41] (current) – ryans
@@ Line 5: / Line 5: @@
 ====Where====
   * There are 4 sets of slits in FRIB, one for each of the sources, one by the end of the FSEE beam line, and one for the charge selector. We only use adjust the source slits.
+  * Control them via the [[pages:sources|Source Pages]] or [[pages:fe_diag|Front End Diagnostics]].
   * K500 also has source slits for its one source
   * does ReA have slits
@@ Line 11: / Line 12: @@
   * Slits being fully closed would be 0mm, 0mm, 0mm, 0mm. Slits being as open as we would set them would be 40mm, 40mm, 40mm, 40mm
   * HPECR slits in FRIB can also be controlled by setting the Vertical Gap and Center, again, do NOT change the horizontal slits
+{{:dev:slit_controls.png?}}
 ====Why====
+  * Source Physicists appreciate regular ''Slit Scans'', which can be found under ''Physics Apps''.
+  * We should also appreciate them, you can always load old Slit Scans to see what portion of beam you're actually cutting
+  * Pictured below is an example of a Slit Scan, the greyed out portion represent beam that's **currently** being blocked by the slits
+  * Generally the slits should be centered on the peak of the desired charge state, as shown below
+  * The left represents the tail end of our desired peak, you can tell as it has an appreciable slope, including more of this, i.e. opening the slits farther left in this instance, will increase beam loss along the accelerator
+  * The right lacks the same severe slope, and thusly is "safer" to include
+  * Regardless, the area under curve between the slits should be proportional to the amount of beam sent
+{{:dev:slitscan.png?}}
+====Who====
+  *Us
+====When===
+  *All the time, babyyy!