Differences

This shows you the differences between two versions of the page.

--- dev:ebends [2025/08/29 01:30] – Added PS, Controls/PPS contact sheet links as well was some minor stylistic tweaks. Removed the WIP tag. look
+++ dev:ebends [2025/08/30 04:50] (current) – look
@@ Line 16: / Line 16: @@
 ===Tips/Notes===
   * When taking the Linac RSS out of Beam Permit, it is good practice to block beam upstream of the E-Bends and then turn off their power supplies before turning the key in the PPS rack.
-  * The controls for the E-Bend power supplies can be on found various pages. The most common page used by operators to turn the E-Bends on and off can be found by going to 'FRIB Launch Page' -> 'MPS Operator'. Other pages are given under the Devices/PV's section of this page.
+  * The controls for the E-Bends' power supplies can be on found various pages. The most common page used by operators to turn the E-Bends on and off is the '[[pages:mps_op|MPS Operator]]' page. Other pages are given under the Devices/PV's section of this page.
   * When trying to turn the E-Bend power supplies back on after a period of not being in Beam Permit, wait ~10-15 seconds after the Beam Permit LED on the PPS rack has turned solid red before attempting to do so. This will give the PVs time to reconnect to CS Studio and thus be able to receive commands from CS Studio pages.
   * All of the E-Bends power supplies should have similar voltage set point magnitudes with one supply in each pair being negatively biased.
@@ Line 34: / Line 34: @@
 ===Personnel===
 There doesn't appear to be a single person/group in charge of the E-Bends. The power supplies themselves are probably owned by the [[https://portal.frib.msu.edu/sites/engineering/electrical/_layouts/15/WopiFrame.aspx?sourcedoc=%7b7b460567-337c-44f6-937e-dfb2701dccbb%7d&action=default&slrid=ee46f0a0-07db-9099-5ad5-ce7078e36218|Power Supply group]]. Any other problems with the E-Bends might be related to [[https://portal.frib.msu.edu/sites/accsystems/controlsandcomputing/_layouts/15/WopiFrame2.aspx?sourcedoc=%7b63ED5457-398D-40E6-973C-643314D0858C%7d|Controls/PPS group]].
+----
+  *Shane: I'd like to see an explicit labelling of them as dipoles, just to better cement what those are for new operators
+  *Shane: you can link the MPS Opsrator page with [[pages:mps_op|this]]