This setup helps you create standalone GET software releases which you can load and test without overwriting your old settings.

• Download Getscripts
• extract it to your home directory.
• copy update2.sh and mmSync to your home directory.
• edit update2.sh and change the release date and the password. If macports and Ice are still screwed up un-comment the export command there.
• execute update.sh and wait for some time.
• when done, cd ~/GET-2014XXXX or whatever release number you have.
• then cd runtime, make any changes to your *.xcfg files
  • you have to synchronize all your macmini farm. open a new terminal window, cd ~ then execute ./mmSync GET-20140516 or whatever version you have
  • This should copy the new release to all mac minis (if you change *.xcfg you have to redo this)
• If there is a new getHwServer-release-2014XXXX.out on the wiki then download it and copy it to /mnt/local/export/filesystem/ then edit startup.vxsh accordingly.
• cd ~/GET-2014XXXX/runtime then open multiple tabs
• type source ../GETUP
  • in multiple tabs
• run getEccServer and getEccClient then GetController

Make sure CoBo is connected to JTAG and powered up. To store the above information in NOR flash. You should have Xilinx EDK/SDK installed. Start Xilinx command prompt environment (if you are in GNU/Linux just source the settings.sh file) if you are using Windows, go to start → Xilinx Design Tools → Accessories → ISE Design Suite command prompt, once it is launched

Change Directory to the folder where the configuration files (attached) are stored e.g. C:\CoBos_Info\configure

• To store vxworks type:

xmd -nx -tcl flashwriter.tcl vx.tcl

• To store the mac address:
  • edit mac.tcl
  • for the board labeled 1233 (serial number sticker) you should use mac_addr_temac-1233.bin
  • for the board labeled 1234 use mac_addr_temac-1234.bin
  • You should run xmd -nx -hw system.xml -tcl flashwriter.tcl mac.tcl

If you want to try a firmware just start xmd by typing xmd in Xilinx shells/command prompt Then type: fpga –f download.bit This should download the bitstream and immediately start the vxworks OS.