Sweeper Magnet

User Tools

Site Tools

Trace:
usb_data_acquisition_setup_guide

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
usb_data_acquisition_setup_guide [2017/05/07 15:51]
pereira 		usb_data_acquisition_setup_guide [2017/06/09 17:52] (current)
pereira
Line 1: Line 1:
 ====== USB Data Acquisition Setup Guide ====== ====== USB Data Acquisition Setup Guide ======
-The USB-based data acquisition is built around the VM-USB (VME) and CC-USB (CAMAC) crate controllers available from Wiener Electronics, according the methods defined in the NSCL DAQ software package **nscldaq11.x**. These controllers contain at their core an FPGA on which the controller firmware is loaded. The controllers have two modes of operation:+The USB-based Sweeper Magnet data acquisition is built around the VM-USB (VME) and CC-USB (CAMAC) crate controllers available from Wiener Electronics, according the methods defined in the NSCL DAQ software package **nscldaq11.x**. These controllers contain at their core an FPGA on which the controller firmware is loaded. The controllers have two modes of operation:
  
   - Interactive mode: commands sent to the USB port are immediately executed and their result returned   - Interactive mode: commands sent to the USB port are immediately executed and their result returned
Line 10: Line 10:
  
  
-The time-ordered data from the Sweeper EVB is sent to the ring buffer **sweeper**, which can then be read by users via analyzer (e.g. SpecTcl, Root, etc.). In order to facilitate the parsing of data from the Sweeper, a pre-unpacker software packet was created to organize data from electronics modules (detectors) into C++ structures.   Users can couple this pre-unpacker into their analysis software. More details about the Sweeper pre-unpacker software can be found [[Pre-unpacker|here]].+The time-ordered data from the Sweeper EVB is sent to the ring buffer **sweeper**, which can then be read by users via analyzer (e.g. SpecTcl, ROOT, etc.). In order to facilitate the parsing of data from the Sweeper, a pre-unpacker software packet was created to organize data from electronics modules (detectors) into C++ structures. Users can couple this pre-unpacker into their analysis software. More details about the Sweeper pre-unpacker software can be found [[Pre-unpacker|here]].
  
  
usb_data_acquisition_setup_guide.1494186682.txt.gz ยท Last modified: 2017/05/07 15:51 by pereira

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki