Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
|
sweeper_daq_tools [2017/07/07 11:01]
pereira [Running in Slave mode with multilogger] |
sweeper_daq_tools [2017/07/07 13:01] (current)
pereira [Level-3 Trigger GUI] |
| |
| ==== Level-3 Trigger GUI ==== | ==== Level-3 Trigger GUI ==== |
| The Level-3 trigger GUI gets started by clicking the button ''Launch Level3 Trigger GUI''. It can be used to select the trigger mode: (1) Sweeper standalone [Sweeper data are processed when there is a Sweeper trigger, typically coming from the Thin left-up PMT (''thin_LU'') of the FP scintillator]; (2) Sweeper singles (Sweeper, MoNA and LISA data are processed whenever there is a Sweeper trigger); and (3) Coincidence Sweeper (Sweeper, MoNA and LISA data are processed whenever there is a coincidence between the Sweeper and MoNA/LISA triggers). | The Level-3 trigger GUI gets started by clicking the button ''Launch Level3 Trigger GUI''. It can be used to select the trigger mode: (1) **Sweeper standalone** [Sweeper data are processed when there is a Sweeper trigger, typically coming from the Thin left-up PMT (''thin_LU'') of the FP scintillator]; (2) **Sweeper singles** (Sweeper, MoNA and LISA data are processed whenever there is a Sweeper trigger); and (3) **Coincidence Sweeper** (Sweeper, MoNA and LISA data are processed whenever there is a coincidence between the Sweeper and MoNA/LISA triggers). |
| |
| {{:wiki:l3gui-start.png|L3 GUI}} | {{:wiki:l3gui-start.png|L3 GUI}} |
| In order to set this module you must: | In order to set this module you must: |
| |
| * Select one of the three possible trigger configurations. | * Select one of the three possible trigger configurations. IMPORTANT NOTE: When running the Sweeper DAQ in standalone mode always select **Sweeper standalone**. When running in Slave mode with MoNA/LISA, you can use either **Sweeper singles** or **Coincidence Sweeper** |
| * Go to the tab ''FPGA Configure''. If the VME crate was power cycled you will need to load the firmware by clicking ''Load'' | * Go to the tab ''FPGA Configure''. If the VME crate was power cycled you will need to load the firmware by clicking ''Load'' |
| * In the tab ''FPGA Configure'', verify that the Coincidence Gate is set to the value 38 {{:wiki:l3gui-fpga.png|L3 GUI FPGA control}} | * In the tab ''FPGA Configure'', verify that the Coincidence Gate is set to the value 38 {{:wiki:l3gui-fpga.png|L3 GUI FPGA control}} |
