preparation_for_tuning_the_s800
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
preparation_for_tuning_the_s800 [2013/12/14 16:30] pereira |
preparation_for_tuning_the_s800 [2015/10/27 09:32] (current) pereira |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Preparation for tuning ====== | ====== Preparation for tuning ====== | ||
| - | * [[Software|Software | + | |
| + | | ||
| + | * [[S800 DAQ tools]] | ||
| * [[Electronics overview|Electronics, | * [[Electronics overview|Electronics, | ||
| + | * [[Vacuum control]] | ||
| * [[Gas handling system]] | * [[Gas handling system]] | ||
| * [[HV bias]] | * [[HV bias]] | ||
| Line 9: | Line 12: | ||
| - | PREPARATION FOR TUNING | ||
| - | In S3 vault | ||
| - | Arm dump switches | ||
| - | Make sure object ion gauge is off | ||
| - | Go to page xx on Panel Mate xxx. Check status xxx | ||
| - | | ||
| - | Make sure gas bottles for FP detectors are open | ||
| - | Make sure Intermediate PPACs have gas | ||
| - | |||
| - | In data-U | ||
| - | Start Software tools | ||
| - | PanelMates | ||
| - | NMR GUIs | ||
| - | Barney | ||
| - | Labview Gas Handling System Controls | ||
| - | Labview Bias Controls | ||
| - | Alarm servers and monitors | ||
| - | Linux HV controls (alarm server should be started first) | ||
| - | SpecTcl (alart server should be started first) | ||
| - | Run Control (in coordination with experimenters) | ||
| - | Trigger Control GUI (in coordination with experimenters) | ||
| - | Scalers (in coordination with experimenters) | ||
| - | Put 10 Amps in Spectrograph dipoles | ||
| - | |||
| - | Start gas in detectors | ||
| - | Refer to Section xx (S800 Focal Plane Gas Handling System Operation) | ||
| - | |||
| - | Enable crad04 with a rate limit of 20 kHz (crad04 looks at E1 up) | ||
| - | If it does not interfere with experimenter preparation (see “Unreacted Beam” section below) | ||
| - | Set spectrograph Brho | ||
| - | Start scalers | ||
preparation_for_tuning_the_s800.1387056603.txt.gz · Last modified: 2013/12/14 16:30 by pereira
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
